workshops:prusa_i3kd
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
workshops:prusa_i3kd [2014/12/14 16:50] – [Configuring the extruder motor] Julien Deswaef | workshops:prusa_i3kd [2014/12/14 16:53] (current) – [Configuration] Julien Deswaef | ||
---|---|---|---|
Line 32: | Line 32: | ||
===== Configuration ===== | ===== Configuration ===== | ||
+ | |||
+ | Here are some values for my Prusa i3kd. (I just keep them here to remember them)\\ | ||
+ | Dimensions of the plateform: | ||
+ | * With (X): 185cm | ||
+ | * Length(Y): 170cm | ||
+ | * Height:(Z): 190cm | ||
==== Configuring the extruder motor ==== | ==== Configuring the extruder motor ==== | ||
Line 65: | Line 71: | ||
Enter this new value like this: < | Enter this new value like this: < | ||
And save by typing this: | And save by typing this: | ||
- | < | + | < |
Repeat 2 or 3 times to get the number right. | Repeat 2 or 3 times to get the number right. | ||
==== Configure Slic3r settings==== | ==== Configure Slic3r settings==== |
workshops/prusa_i3kd.1418572235.txt.gz · Last modified: 2014/12/14 16:50 by Julien Deswaef