workshops:prusa_i3kd
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
workshops:prusa_i3kd [2014/12/09 21:29] – [Shops] Julien Deswaef | workshops:prusa_i3kd [2014/12/14 16:53] (current) – [Configuration] Julien Deswaef | ||
---|---|---|---|
Line 32: | Line 32: | ||
===== Configuration ===== | ===== Configuration ===== | ||
+ | |||
+ | Here are some values for my Prusa i3kd. (I just keep them here to remember them)\\ | ||
+ | Dimensions of the plateform: | ||
+ | * With (X): 185cm | ||
+ | * Length(Y): 170cm | ||
+ | * Height:(Z): 190cm | ||
==== Configuring the extruder motor ==== | ==== Configuring the extruder motor ==== | ||
- | In pronteface..py: \\ | + | In pronteface.py: |
- | < | + | < |
- | Read < | + | |
- | Then extrude 10cm (using pronterface) and measure the actual amount of filament extruded. \\ | + | |
- | (M92 E###) * ( 10cm / measured) = new value for M92 | + | Ex: |
+ | < | ||
+ | >>> | ||
+ | SENDING: | ||
+ | echo:Stored settings retrieved | ||
+ | echo:Steps per unit: | ||
+ | echo: | ||
+ | echo: | ||
+ | echo: M203 X500.00 Y500.00 Z3.00 E25.00 | ||
+ | echo: | ||
+ | echo: M201 X9000 Y9000 Z100 E10000 | ||
+ | echo: | ||
+ | echo: M204 S3000.00 T3000.00 | ||
+ | echo: | ||
+ | echo: M205 S0.00 T0.00 B20000 X20.00 Z0.40 E5.00 | ||
+ | echo:Home offset (mm): | ||
+ | echo: M206 X0.00 Y0.00 Z0.00 | ||
+ | echo:PID settings: | ||
+ | echo: M301 P22.20 I1.08 D114.00 | ||
+ | </ | ||
- | Enter < | + | Read the ligne that starts with '' |
- | < | + | Then use a ruler to mark 10 cm of filament and launch an extrusion of 10cm of filemant using pronterface. Then measure |
+ | |||
+ | (M92 E###) * ( 10cm / measured) = new value for M92 | ||
+ | Enter this new value like this: < | ||
+ | And save by typing this: | ||
+ | < | ||
+ | Repeat 2 or 3 times to get the number right. | ||
==== Configure Slic3r settings==== | ==== Configure Slic3r settings==== | ||
* filament diameter : measure it from the actual filament used (do multiple measures and average it) | * filament diameter : measure it from the actual filament used (do multiple measures and average it) |
workshops/prusa_i3kd.1418156965.txt.gz · Last modified: 2014/12/09 21:29 by Julien Deswaef